TEMPARIN MAX 

Temparin Max is designed to repair with the same ingredients dentists use. This is a TEMPORARY REMEDY meant to replace a lost filling, cap,crown or inlay until you have a chance to visit your dentist and should only be removed by a dental professional. Visit dentist within 48 hours of use.

Caution:

To avoid infection and/or serious injury, this product should not be used if there is throbbing pain,ulceration,or swelling in the affected area. If any of these symptoms exist consult your dentist immediately,This product should not be place on an open wound. Do not use if allergic to Eugenol. READ ALL OF THE DIRECTIONS CAREFULLY BEFORE USE! 

Wash and dry your hands. Do not get unused Temperin Max wet. Use only what is needed to repair the dental emergency, and save the rest for future application.

KEEP OUT OF REACH OF CHILDREN.

DIRECTIONS TO REPLACE A LOST FILLING:

Wash the cavity area with warm water and do not dry. Cut with spade tool or pinch a small amount of Temperin Max from the vial and roll into a ball between fingers. Slightly overfill the cavity with Temperin Max and pack into place with applicator tool tip. Close your teeth together,as if you were biting down on apiece of paper, and gently chew or grind on the replaced filling to create a comfortable bite. use a moist cotton swab to remove excess Temperin Max from around the area. Moisture will accelerate the set. Temperin Max will set softly in your mouth within a few minutes, but avoid chewing on the repair for 2-3 hours to allow the material to fully set.

Directions to secure loose crowns,caps,or inlays:

Try the crown, cap,or inlay first to see if you can fit it accurately back onto the tooth surface. If you are not able to do so, or if remaining tooth is cracked, then do not proceed further. If the crown has a post attached to it  or if there is tooth surface remaining inside the crown. Temperin Max may not adhere. Carefully rinse the tooth area and the inside of the crown, cap, or inlay with warm water ,and do not dry. cut with spade tool or pinch a small amount of Temperin Max from the vial, roll into a ball between fingers ,and place evenly inside the crown ,cap, or inlay . Place the crown ,cap,or inlay on the tooth and bite down,applying pressure to to push into the position. Temperin Max will begin to harden within a few minutes , but avoid chewing on the repair for at least 2-3 hours to allow the material to set. Use a toothbrush to gently clear away any excess material from around the crown,cap, or inlay.

Ingredients: aluminum sulfate, aluminum phosphate, calcium sulfate, eugenol, iron oxides, menthol, paraffin, petrolatum, potassium alum, zinc oxide.

***PLEASE CALL (805) 241-0935 TO PLACE YOUR ORDER OVER THE PHONE***